No products in the cart.
Jeep Wrangler / Gladiator Mileage Odometer Blocker
2018–2026
Price range: €210.00 through €260.00
Shipping calculated at checkout.
- Supported Jeep Wrangler / Gladiator years: 2018–2026. Confirm exact production date, dashboard/cluster and connector before ordering.
- Plug-and-play / no cutting or soldering where the selected CEL hardware supports this installation; verify exact connector and installation location.
- Switch modes by holding the OK button for 5 seconds.
- ON: Works; OFF: Factory behavior
WARNING:
This product is intended for OFF-ROAD and DYNO testing only.
Use on public roads may violate local laws. We are
NOT responsible for any vehicle damage, malfunction, or engine failure.
Buyer assumes all risk and liability. Use at your own risk.
Buyer assumes all risk and liability. Use at your own risk.
PRODUCT DESCRIPTION
OPERATING MODES
Change operating profile by holding OK for 5 seconds
Hold the OK button for 5 seconds to switch between FREEZE and BYPASS.
The speedometer displays actual speed in both modes.
1
cel-blue
FREEZE
Distance recording: 0%
SPEEDOMETER DISPLAYS
Works normally
INDICATION
1 confirmation flash
EXAMPLE
100 km/h – 100 km/h
100 km – 0 km
2
cel-green
BYPASS
Distance recording: 100%
SPEEDOMETER DISPLAYS
Factory behavior
INDICATION
2 confirmation flashes
EXAMPLE
100 km/h – 100 km/h
100 km – 100 km
MODE SWITCHING
Hold the OK button for 5 seconds to select the other mode. Release the button before the next hold.
The module confirms the selected mode using 1 or 2 hazard flashes:
⚠x1 flash = Mode 01 (FREEZE) ⚠x2 flashes = Mode 02 (BYPASS)
Selected mode remains saved after an ignition cycle.
INSTANT SWITCHING
Hold OK for 5 seconds to change modes
SETTINGS SAVED
Selected mode remains stored after ignition cycle
PLUG & PLAY
No permanent modifications required. 100% safe
