No products in the cart.
FREEZE
- Distance recording
- 0%
- Speedometer
- 0 km/h
- Confirmation
- 1 indicator flash
- 100 km distance example
- 0 km recorded
Audi Q5/SQ5 8R Mileage Odometer Blocker
2008–2017
Price range: €240.00 through €310.00
Shipping calculated at checkout.
- Supported Audi Q5/SQ5 8R years: 2008–2017. Confirm exact production date, dashboard/cluster and connector before ordering.
- Plug-and-play / no cutting or soldering where the selected CEL hardware supports this installation; verify exact connector and installation location.
- Switch between operating modes in seconds.
- VERIFY: Verify
Product-specific technical information
Select a cockpit type to view its operating modes. This also sets your cockpit choice above.
Five modes. Speedometer behaviour changes with the selected mode.
LIMITED 10%
- Distance recording
- 10%
- Speedometer
- 10% of actual speed
- Confirmation
- 2 indicator flashes
- 100 km distance example
- 10 km recorded
LIMITED 25%
- Distance recording
- 25%
- Speedometer
- 25% of actual speed
- Confirmation
- 3 indicator flashes
- 100 km distance example
- 25 km recorded
LIMITED 50%
- Distance recording
- 50%
- Speedometer
- 50% of actual speed
- Confirmation
- 4 indicator flashes
- 100 km distance example
- 50 km recorded
BYPASS
- Distance recording
- 100%
- Speedometer
- Actual speed
- Confirmation
- 5 indicator flashes
- 100 km distance example
- 100 km recorded
Activation & controls
Cycle through the Analogue Cockpit modes using 4 quick high-beam flashes. The number of confirmation flashes identifies the selected mode (1–5).
The selected mode is retained while the backup power remains available.
When cruise control is active, this firmware passes the actual speed signal to the cockpit. The speedometer behaviour shown above applies with cruise control inactive.
Confirm assistance-system behaviour for your exact vehicle configuration with our support team.
Four modes. The speedometer displays the actual speed in every mode.
FREEZE
- Distance recording
- 0%
- Speedometer
- Actual speed
- Confirmation
- 1 indicator flash
- 100 km distance example
- 0 km recorded
LIMITED 5%
- Distance recording
- Approx. 5%
- Speedometer
- Actual speed
- Confirmation
- 2 indicator flashes
- 100 km distance example
- Approx. 5 km recorded
LIMITED 10%
- Distance recording
- Approx. 10%
- Speedometer
- Actual speed
- Confirmation
- 3 indicator flashes
- 100 km distance example
- Approx. 10 km recorded
BYPASS
- Distance recording
- 100%
- Speedometer
- Actual speed
- Confirmation
- 4 indicator flashes
- 100 km distance example
- 100 km recorded
Activation & controls
Cycle through the Virtual Cockpit modes using 4 quick high-beam flashes. The number of confirmation flashes identifies the selected mode (1–4).
The selected mode is retained while the backup power remains available.
Confirm assistance-system behaviour for your exact vehicle configuration with our support team.
WARNING:
This product is intended for OFF-ROAD and DYNO testing only.
Use on public roads may violate local laws. We are
NOT responsible for any vehicle damage, malfunction, or engine failure.
Buyer assumes all risk and liability. Use at your own risk.
Buyer assumes all risk and liability. Use at your own risk.
PRODUCT DESCRIPTION
OPERATING MODES
Change operating profile with 4 high-beam flashes
Choose the desired profile using 4 quick high-beam flashes.
The module confirms selection using hazard indicator flashes.
No data was found
MODE SWITCHING
Switch modes anytime by performing 4 quick high-beam flashes.
The module confirms the selected mode using 1–3 hazard flashes:
âš x1 flash = Mode 01 (FREEZE)Â âš x2 flashes = Mode 02 (LIMITED)Â âš x3 flashes = Mode 03 (BYPASS)
Selected mode remains saved after ignition cycle.
INSTANT SWITCHING
Change modes anytime in seconds
SETTINGS SAVED
Selected mode remains stored after ignition cycle
PLUG & PLAY
No permanent modifications required. 100% safe
